37120-7960 Propeller Shaft For Hino Bus Genuine
 

Engine Assembly and Engine Parts for More models as following:

Office:

More Spare Parts:


 

Packing:


Wearhouse:

Tips:

Causes of failure of the anti-lock braking system:

1, may be the brake pad wear seriously, the brake pad is divided into two kinds with induction line and without induction line, with the induction line will be in the brake pad wear to the limit position, the induction line will automatically connect to the circuit, then the fault light will be lit. Brake pads without induction lines do not automatically alarm, but through the sizzling sound of "iron rubbing iron" to tell you that you need to replace the brake pads;

2, if it is a problem of brake pad wear, then theoretically speaking, the vehicle can at least drive hundreds of kilometers, but it is not recommended to continue to drive, because the brake pad wear will lead to longer braking distance, softer, noisy, injury to the brake disc. It is best for car owners to develop the habit of changing brake pads regularly, and choose the replacement cycle according to their driving habits and road conditions;

3, may be the brake oil level is too low, brake fluid in the car's braking system plays a vital role, when the driver steps on the brake pedal, the force from the pedal down, by the piston of the brake general pump, through the brake fluid to transmit energy to the brake sub-pump loed in the wheel, so that the brake pad and the wheel contact, to achieve the purpose of preventing the vehicle from moving forward. The absence of brake fluid will also be accompanied by a significant shortage of braking force, and even a serious loss of braking force. In this CA-SE, as long as the brake fluid is replenished in time..

A series of special devices with a braking system that enables the car's travel speed to be forcibly reduced. The braking system is mainly composed of four parts: energy supply device, control device, transmission device and brake. The main function of the braking system is to slow down or even stop the moving car, to keep the speed of the downhill car stable, and to keep the stopped car still.

1． Symptom

The brake pedal travel is too large, the braking effect is slow, the braking efficiency is very low or even lost, and the braking distance is increased.

2． The cause of the failure

1) Insufficient brake oil pressure.

2) There is air in the braking system

3) The free travel of the brake pedal or the brake gap is too large, the friction pad of the brake shoe is in poor contact, the wear is serious or there is oil

4) Brake master cylinder, wheel cylinder piston and cylinder tube wear or strain, leather bowl aging damage

3． Judgment and troubleshooting of faults

1) Continuously press the brake pedal, such as the pedal gradually rising and there is a feeling of elasticity, but after a short pause and then pedal is still very low, that is, there is air in the braking system, then the braking system should be exhausted

2) One foot brake is not effective, but the braking effect is very good when pedaling several times in a row, generally the free travel of the brake pedal is too large or the brake gap is too large. The pedal free travel should be adjusted, followed by checking the brake clearance and, if necessary, repairing the brake disintegration

3) When pressing the brake pedal, it is not weak and unsinkable, but the braking effect is poor, which is the failure of the wheel brake, such as the brake shoe blade has oil or poor contact, the friction pad is aging, wear, and the brake drum wear is uneven. The condition of the braking technology should be checked and, if necessary, adjusted and repaired.